WIRINGTHE SYSTEM
IMPORTANT: Make sure all equipment is turned off before
making any connections.
For speaker connections, use a minimum #16-gauge speaker
wire with polarity coding.The side of the wire with a ridge or
other coding is usually considered positive polarity (i.e., +).
NOTE: If desired, consult your local Infinity dealer about speaker
wire and connection options.
The speakers have coded terminals that accept a variety of wire
connectors.The most common connection is shown in Figure 5.
To ensure proper polarity, connect each + terminal on the back
of the amplifier or receiver to the respective + (red) terminal on
each speaker, as shown in Figure 6. Connect the � (black)
terminals in a similar way. See the ownerOs guides that were
included with your amplifier, receiver and television to confirm
connection procedures.
IMPORTANT: Do not reverse polarities (i.e.,+ to � or � to +)
when making connections.Doing so will cause poor imaging and
diminished bass response.
(one channel shown)
RED = +
BLACK = �
BLACKRED
1. LOOSEN TERMINALS
2. INSERT BARE END; Receiver or
TIGHTEN TERMINALSAmplifier
(rear view)�+
NO STRIPE = �STRIPE = +
+�
Speaker (rear view)
FIGURE 5� This example shows how to connect bare wires to theFIGURE 6� Wiring diagram shows polarity connections for one
terminals.Banana plugs may also be inserted directly into the rear of thechannel of a stereo or home theater system.
connector.
4ENTRA |